Table of Contents
Advertisement
(3)
Release 2 latches and take off the terminal
cover on the front side.
(4)
Release 1 latch and take off the terminal
cover on the rear side.
(5)
Remove the terminal and spring. Then take
off the transfer charger wire.
(6)
Remove the cushioning material, disconnect
the terminal and remove the spring. Then
take off the separation charger wire.
Notes:
1. Insert the wire securely into the V-
grooves of the front and rear sides.
2. Do not twist the wire.
3. Do not touch the wire directly with bare
hands.
[O] Transfer unit
Note:
When taking off the transfer unit, take off the process unit first to prevent the drum from light.
(1)
If the ADU is not installed, take off the right
front hinge cover, the right rear hinge cover
and the bypass upper cover (
Right front hinge cover",
rear hinge cover",
upper cover").
If the ADU is installed, take off the ADU
(
P.15-10 "[A] Automatic Duplexing Unit
(ADU)").
(2)
Take off the bypass unit
(
P.9-17 "[G] Bypass unit").
(3)
Release 1 latch and take off the transport
guide.
June 2004 © TOSHIBA TEC
P.2-32 "[P]
P.2-33 "[Q] Right
P.2-33 "[R] Bypass
11 - 15
04/09
Terminal cover
Fig.11-27
Cushioning material
Terminal
Spring
Separation charger wire
Fig.11-28
Latch
Transport guide
Fig.11-29
e-STUDIO200L/230/280 DRUM RELATED SECTION
Transfer charger wire
11
Advertisement
Table of Contents
