Table of Contents
Advertisement
(4)
Disconnect 1 connector, release the latch,
and then take off the 1st transport sensor.
[Q] Exhaust fan
(1)
Take off the ozone filter
(
P.11-13 "[L] Ozone filter").
(2)
Take off the transfer/separation charger (
P.11-14 "[M] Transfer/Separation charger").
(3)
Take off the transfer unit
(
P.11-15 "[O] Transfer unit").
(4)
Take off the guide
(
P.11-16 "[P] 1st transport sensor").
(5)
Remove the plate spring.
(6)
Remove 2 springs and 5 screws.
(7)
Take off the case while pulling the opening/
closing lever.
June 2004 © TOSHIBA TEC
1st transport sensor
Fig.11-33
Plate spring
Fig.11-34
Case
Fig.11-35
e-STUDIO200L/230/280 DRUM RELATED SECTION
11 - 17
11
Spring
Advertisement
Table of Contents
