Table of Contents
Advertisement
[G] Bypass unit
(1)
If the ADU is not installed, take off the right
front hinge cover, the right rear hinge cover
and the bypass upper cover
(
P.2-32 "[P] Right front hinge cover",
P.2-33 "[Q] Right rear hinge cover",
33 "[R] Bypass upper cover").
If the ADU is installed, take off the ADU
(
P.15-10 "[A] Automatic Duplexing Unit
(ADU)").
(2)
Open the side cover.
(3)
Disconnect 2 connectors. Remove 5 screws
and take off the bypass unit.
Note:
Make sure to let the disconnected connector
(A) (harness) through the hole (B).
[H] Bypass tray
(1)
Take off the bypass unit
(
P.9-17 "[G] Bypass unit").
(2)
Disconnect 1 connector. Remove 2 screws
and take off the bypass tray.
Note:
The bypass tray is removable without taking
off the bypass unit from the equipment.
(3)
Pull out the hinge assembly from the bypass
tray.
June 2004 © TOSHIBA TEC
P.2-
Bypass tray
e-STUDIO200L/230/280 PAPER FEEDING SYSTEM
9 - 17
04/09
A
B
Bypass unit
Fig.9-21
Fig.9-22
Hinge
Fig.9-23
9
Advertisement
Table of Contents
