Toshiba e-STUDIO200L/230/280 SERIES Service Manual page 151

Note:
Rotate the drive pulley to move the carriage.
(4) Disconnect 1 connector from the inverter
board. Pull out the harness from 2 harness
clamps and the frame of the carriage.
Note:
When disconnecting the connector, make
sure not to overload the carriage frame.
(5) Move the carriage-1 to the position where
the exposure lamp is seen through the cutout
of the frame.
Note:
Rotate the drive pulley to move the carriage.
June 2004 © TOSHIBA TEC
Fig.6-30
Fig.6-31
Fig.6-32
6 - 21
Drive pulley
Carriage-1
e-STUDIO200L/230/280 SCANNER
6