Disassembly And Replacement - Toshiba e-STUDIO200L/230/280 SERIES Service Manual

10.4 Disassembly and Replacement

[A] Main motor
(1) Take off the SYS board case
( P.2-36 "[D] SYS board case").
(2) Disconnect 1 connector. Remove 2 screws,
release 2 locking support, and then take off
the main motor.
[B] Main motor drive unit
(1) Take off the process unit
( P.11-8 "[A] Process unit").
(2) Take off the SYS board case
( P.2-36 "[D] SYS board case").
(3) Take off the connecting port cover
( P.2-32 "[O] Connecting port cover").
(4) Remove 1 screw and take off the flywheels.
(5) Remove 1 screw. Take off the bracket fixing
the registration clutch and bushing.
June 2004 © TOSHIBA TEC
Screw
Screw
Connector
Fig.10-3
Flywheel
Fig.10-4
Bushing
Bracket
Fig.10-5
e-STUDIO200L/230/280 DRIVE SYSTEM
10 - 5
Main motor
10