Table of Contents
Advertisement
[I]
Carriage wire / Carriage-2
(1)
Take off the carriage-1
(
P.6-22 "[F] Carriage-1").
(2)
Install the wire holder jig to each pulley on
front and rear sides, not to loosen the car-
riage wire.
Note:
Refer to "3.7.1 Carriages" in the Service
Handbook for the installation direction of the
wire holder jig.
(3)
Remove the tension springs on both front
and rear sides.
(4)
Remove the carriage wires on both front and
rear sides.
(5)
Rotate the carriage-2 in the direction where
the inside of the frame is dented shown in
the figure at right, not to touch the mirror.
Then take off the carriage-2.
June 2004 © TOSHIBA TEC
Fig.6-41
Tension spring
Carriage wire
Carriage wire
Fig.6-42
Fig.6-43
6 - 25
Wire holder jig
Tension spring
Carriage-2
e-STUDIO200L/230/280 SCANNER
6
Advertisement
Table of Contents
