Soft Keys - Dräger Fabius OS Instructions For Use Manual

Soft Keys

The functions of the six soft keys located below the
the screen are indicated by the labels shown above
each key. The labels change depending on the cur-
rent mode:
1 In Standby mode, the following soft key labels
appear at the bottom of the Standby screen:
– »Run System Test«
– »Calibrate Flow Sensor«
– »Calibrate O Sensor«
2
– »Leak / Compl Test«
– »Access Alarm Log«
– »Restore Site Defaults«
See "Configuration Functions in Standby Mode" on
page 108 for complete information.
2 In any ventilation mode, the soft keys labels
show the ventilation parameters and functions
that are available in that particular ventilation
mode (Volume Control mode parameters are
shown in the example illustration).
3 If the » « key (Setup) is pressed in any ven-
tilation mode, the following soft keys appear at
the bottom of the screen:
– »Volume Alarms On/Off«
– »Auto Set«
– »Calibrate O Sensor«
2
– »Des Comp On/Off«
– »Access Alarm Log«
– »Access Alarm Volume«
NOTE:
The »Volume Alarms On/Off« soft key label does
not appear in ManSpont mode because it is select-
able on the ManSpont screen.
See "Configuration during Operation" on page 127
for complete information.
Instructions for Use Fabius OS SW 3.n
1
2
3
Operation Concept
33