Table of Contents
Advertisement
Operation - Auto Leveling Control Touch Pad
Unhitching Instructions
o P E R AT I o N - A U T o L E V E L I N G c o N T R o L T o U c H PA D
NOTE: Prior to unhitching from the tow vehicle, ensure trailer is parked on a level surface and chock the
tires of the trailer.
1.
To turn on the touch pad, press both "UP" and "DOWN" arrows (Fig. 1B and Fig. 1C) at the same time.
The green indicator LED (Fig. 1A) will turn on.
UNHITcHING INSTRUcTIoNS
NOTE: The touch pad will remain on as long as the user is pressing buttons. It will time out after
approximately 7 minutes without use.
AUTo LEVEL
2.
Press the "UP" arrow (Fig. 1B) to extend the front jacks and lift the front of trailer to take the weight of
the trailer off of the hitch.
AUTo LEVEL SEQUENcE
3.
Uncouple the trailer connection on the tow vehicle.
4.
Pull tow vehicle away and park at a safe distance.
Auto Level
HITcH REco GNITIoN - REcoNNEcTING To ToW VEHIcLE
NOTE: Once the automatic leveling cycle has been started, it is important that there is no movement in the
trailer until the trailer has completed the leveling process. Failure to remain still during the leveling
cycle could have an effect on the performance of the leveling system.
1.
After unhitching from tow vehicle press "AUTO LEVEL" (Fig. 1D).
NOTE: Pressing any button during an Auto Level sequence will abort the auto leveling cycle.
Auto Level Sequence
NOTE: Sequence may vary slightly based on the height of the trailer king pin prior to leveling.
1.
When the Auto Level sequence begins, the front of the trailer will seek a position near a level state,
then the trailer will level from front to back.
2.
The left side jack(s) extend to ground (left mid and left rear).
3.
The right side jack(s) extend to ground (right mid and right rear).
4.
Jack pairs will extend as needed in order to level the trailer.
NOTE: Step 4 may repeat several times if the controller deems necessary.
NOTE: If the AUTO LEVEL sequence does not perform as described above, place the system in manual
mode and test that the jacks operate correctly by pushing their coordinating buttons on the
OneControl Touch Panel inside the trailer; e.g., "FRONT" button operates only the front jacks, etc.
See Operation - MyRV OneControl Touch Panel in this manual.
Hitch Recognition - Reconnecting to Tow Vehicle
1.
To turn on the touch pad, press both "UP" and "DOWN" arrows (Fig. 1B and Fig. 1C) at the same time.
The green indicator LED (Fig. 1A) will turn on.
2.
Press "HITCH HEIGHT" (Fig. 1E). The rear jacks will retract.
3.
The front of the trailer will raise to the height where the auto level sequence was started.
NOTE: If the front of the trailer was below level when the Auto Level process was initiated, the hitch
recognition feature will retract the rear jacks but will not retract the front jacks to lower the trailer
to the initial hitch height. This feature helps prevent injury and/or damage to anything underneath
the trailer.
4.
Connect tow vehicle and make sure trailer and hitch are connected and locked.
5.
Press "RETRACT ALL" System will immediately retract all jacks.
Rev: 03.25.19
01539
VA N L E I G H B E A c o N
VA N L E I G H B E A c o N
Page 5
95
95
9 5
9 5
CCD-0001539
Advertisement
Chapters
Table of Contents
Troubleshooting
