Table of Contents
Advertisement
10 8
10 8
Troubleshooting
T R o U B L E S H o o T I N G
Error Display In LCD Screen
Faults can only be cleared via the OneControl Touch Panel or OneControl Leveling App through MyRV.
The only exception is when the Auto Leveling Control mini-touch pad (Fig. 1) was used to abort an auto-
sequence. In this case the fault can be cleared by pressing any Auto Leveling Control button.
ERRoR DISPLAY IN LcD ScREEN
LCD Message
"EXCESS ANGLE"
"EXCESSIVE ANGLE"
"BAD CALIBRATION"
"FEATURE DISABLED"
"LOW VOLTAGE"
"OUT OF STROKE"
"EXTERNAL SENSOR"
"JACK TIME OUT"
"AUTO LEVEL FAILURE"
"FUNCTION ABORTED"
1 0 8
1 0 8
Rev: 03.25.19
What's Happening?
Table 17. Level-Up Troubleshooting - Error Display in LCD Screen
Unsecured controller.
Uneven or sloped site.
Controller not properly
secured.
Excessive angle reached
during manual operation.
Sensor calibration values are
out of range.
Hitch recognition requested
but no hitch height set.
Zero point not set.
Bad connection or wiring.
Discharged or bad battery.
Unsecured controller.
Uneven or sloped site.
Bad connection or wiring.
System could not level in
expected time.
Unsecured controller.
Voltage drop.
User has aborted an automatic
leveling sequence.
VA N L E I G H B E A c o N
VA N L E I G H B E A c o N
What Should Be Done?
Check and secure controller
placement.
Relocate the trailer.
Check and secure controller
placement.
Relocate the coach.
Replace controller.
Perform "AUTO LEVEL" sequence
to establish hitch height.
Set zero point.
Check wiring - repair or replace.
Test battery voltage under load -
charge or replace.
Check and secure controller
placement.
Relocate the trailer.
Replace or repair connection to
rear remote sensor.
Check for obstructions, leaks,
fluid level and voltage to power
unit motor under load.
Check and secure controller
placement.
Test battery voltage under load -
charge or replace.
Restart the sequence.
Page 18
R
CCD-0001539
Advertisement
Chapters
Table of Contents
Troubleshooting
