Plumbing Functions Within The Spyder Controls; Figure 37. Sanitize The Water Tank Before First Use - Tiffin Motorhomes VANLEIGH BEACON Owner's Manual

Plu M b ing sY sTe M s 1 3 9

Figure 37. Sanitize the Water Tank before First Use

Small amounts of contaminants and minerals are found in ALL water. They can sometimes
cause your fresh water to have an odor. Usually, untreated well water is the source of water
system odors. See "Sanitizing the Fresh Water System" on page 152.
Water pump switch
When the water pump switch is turned ON, the water pump runs until 45 pounds of pres-
sure has been achieved. Turn the water pump switch OFF when it is not in use.
The Water Pump switches illuminate, when in the ON position.
Tank heat button
This button will activate heaters for the tanks to prevent them from freezing. The tank
heater does not turn on automatically. You will need to manually turn on the tank heater if
there is a risk for freezing weather. The tank heaters will keep all three types of tanks (fresh
water, gray water, and holding tank), at just above freezing.

PLUMBING FUNcTIoNS WITHIN THE SPYDER coNTRoLS

The plumbing-related functions include displaying the levels of fresh water, gray water,
black water. Sensors installed in the holding tanks relay the tank level to the Spyder con-
trols. These functions are controlled using the labeled buttons on the touchscreen.
VA N L E I G H B E A c o N 1 3 9