1 94
Turn ON power to TV Roof Antenna.
Once the antenna is activated, you may automatically search for channels that are active in
your area by editing and scanning the channels by using your remote control.
Searching for channels
1.
Press the power button to turn the television ON.
2.
Press Settings.
3.
Go to Channels, press "OK"
4.
Go to Auto Tuning, press "OK".
5.
Press "OK" on Start.
6.
After Auto Tuning is complete, press the "EXIT" button.
NOTE:
You will have to search for TV stations when moving to a new location or cycling
between a cable connection and the over-the-air antenna.
cABLE/SATELLITE oUTLET
Located in the exterior wet bay compartment are three ports for providing your RV with
television service. The three ports are:
The cable input connects to an RG6 cable run through in-line splitters to provide service
•
at multiple locations.
•
The Satellite inputs connect to RG6 cables run directly to specific locations (no splitters).
This allows for clean trans-fer of HD signals from the satellite dish.
•
The Aux input connects to the SAT2 port in the bedroom.
When hooking up cable, make sure that the antenna booster is off (meaning, the green light
is not illuminated). When hooking up a satellite receiver, the feed from the exterior satellite
comes from a port above the radio labeled SAT1. When you hook a coaxial cable from the
1 9 4
e leC T roni C s
Figure 99. Water Pump Switch
VA N L E I G H B E A c o N