2 12
•
For error codes, the
error code (see below).
red led error Code
2
3
4
5
6
8
9
When an error code is present, the board needs to be reset. Energizing the extend/retract
switch resets the board. Energize the extend/retract switch again for normal operation.
checking fuses
The IN-WALL slide system requires a minimum of 30-amp fuse. Check the fuse box (lo-
cated in the command center) for blown fuses, and replace as necessary. If the fuse blows
immediately upon replacement, there may be a problem with the wiring to the control box
(contact your dealer for assistance).
Low voltage
The IN-WALL slide controller is capable of operating the electric slide room with as little as
8-volts. But at these lower voltages the amperage requirement is greater. Check the voltage
at the controller; if the voltage is lower than 11-volts, it is recommended that the auxiliary
battery be placed on a charger until it is fully charged.
only one (1) side moving
The IN-WALL slide system has a separate motor to operate each side of the room. If only
one side of the room moves a short distance (2 to 4 inches) and stops:
Will the non-moving side move with help?
•
If only one (1) side of the room is moving, then with someone's assistance press the
switch to extend or retract the room while pushing the non-moving side in the appro-
priate direction. On larger rooms it may be necessary to have two (2) or more people
pushing the room.
2 1 2
s li d eo u T sYsTe Ms
RED LED
will blink between two and nine (2-9) times to indicate the
Table 22. Error Codes for the Schwintek In-Wall Slide System
Battery drop out; battery capacity low enough to drop below 6
volts while running.
Low battery; voltage below 8 volts at start of cycle.
High battery; voltage greater than 18 volts.
Excessive motor current; high amperage, also indicated by one
(1) side of slide continually stalling.
Motor short circuit; motor or wiring to motor has shorted out.
Hall signal not present; encoder is not providing a signal.
Hall power short; power to encoder has been shorted to ground.
Usually a wiring problem.
VA N L E I G H B E A c o N
error Code description