6.
Continue this flushing process for approximately five (5) minutes allowing ample
time for the fresh water to agitate the stagnant water on the bottom of the tank and
force the deposits through the drain opening.
7.
Upon completion of the steps above, close the drain plug as well as the relief valve.
Refill with fresh water, circulate and rinse.
If you use your vehicle frequently or for long periods of time, flushing the water heater sev-
eral times a year will pro-long the life of the water heater storage tank.
Water heater will not fire up
•
Check for obstructions in burner tube and exhaust.
•
Check 12 Volt power for possible blown fuse.
•
Bad circuit board. See your dealer or Vanleigh Tech Support.
Water heater has disappeared from the main control pad
1.
Go to the settings menu on your main touch panel.
2.
Select screen settings.
3.
Disable the screen power saver.
WATER PUMP
Pump will not start
•
Check that house battery disconnect switch is on.
•
Check pump button at the Spyder contols.
•
Check fuse in power center. See
•
Check to see if water is frozen.
Will not prime, sputters (no discharge, but the motor runs)
•
Check to see if there is water in the tank, or if air collected in the hot water heater.
•
Check for frozen water lines or water tank.
Pump will not shut off, runs when faucet is closed
•
Turn off the pump or city water supply.
•
Check for damp areas around plumbing appliances.
b a si C T rouble s Ho oTing
"Figure 31. 12V Fuse Panel" on page
VA N L E I G H B E A c o N
130.
2 47
2 47