Basic Jack Operation; Unhitching Instructions; Auto-Level; Auto Level Sequence - Tiffin Motorhomes VANLEIGH BEACON Owner's Manual

BASIc JAcK oPERATIoN

UNHITcHING INSTRUcTIoNS

AUTo - LEVEL

AUTo LEVEL SEQUENcE

Basic Jack Operation
1.
Press RETRACT (Fig. 13A) or EXTEND (Fig. 13B) and "front" arrow (Fig. 13D) to operate front jacks.
2.
Press RETRACT or EXTEND, then "rear" arrow (Fig. 13G) to operate rear jacks (right rear, right mid, left
rear and left mid).
3. Press RETRACT or EXTEND, then "right" arrow (Fig. 13F) to operate right jacks (right mid and right rear).
4.
Press RETRACT or EXTEND, then "left" arrow (Fig. 13E) to operate left jacks (left mid and left rear).
5.
Press AUTO LEVEL (Fig. 13H) to start auto-level sequence.
Unhitching Instructions
NOTE: Prior to unhitching from the tow vehicle, ensure trailer is parked on a level surface and chock the
tires of the trailer.
1.
Turn the Linc remote on (Fig. 13I) and enter a PIN code to turn system on.
2.
Press the LEVELER button.
3. Press EXTEND (Fig. 13B) and FRONT arrow (Fig. 13D) to extend front jacks and lift front of trailer to take
the weight of the trailer off of the hitch.
4.
Uncouple the trailer connection on the tow vehicle.
5.
Pull tow vehicle away and park at a safe distance.
Auto Level
NOTE: Once the automatic leveling cycle has been started, it is important that there is no movement in the
trailer until the trailer has completed the leveling process. Failure to remain still during the leveling
cycle could have an effect on the performance of the leveling system.
1.
After unhitching from the tow vehicle press "AUTO LEVEL" (Fig. 13H).
NOTE: Pressing any button on the Linc™ remote during an Auto Level sequence will abort the auto leveling
cycle. To restart the Auto Level process, refer to the OneControl Touch Panel (Fig. 2).
Auto Level Sequence
NOTE: Sequence may vary slightly based on the height of the trailer king pin prior to leveling.
1.
When the Auto Level sequence begins, the front of the trailer will seek a position near a level state,
then the trailer will level from front to back.
2.
The left side jack(s) extend to ground (left mid and left rear).
3.
The right side jack(s) extend to ground (right mid and right rear).
4.
Jack pairs will extend as needed in order to level the trailer.
NOTE: Step 4 may repeat several times if the controller deems necessary.
Rev: 03.25.19
9
Fig. 16
A
VA N L E I G H B E A c o N VA N L E I G H B E A c o N
Page 15
1 0 5 1 0 5
Fig. 17
A
CCD-0001539
1 0 5 1 0 5