Installing A Hitch Below The Bumper; Figure 129. Awning Fuse - Tiffin Motorhomes VANLEIGH BEACON Owner's Manual

2 18
closing the awning
NOTE: Pinch Hazard – when closing the awning, the bottom arm will fold down and
against the back channel. This area must be kept clear of people and objects.
Failure to heed this warning could cause severe personal injury and/or property
damage.
1. Locate the AWNING page on the Spyder control screen.
2. Press and hold the RETRACT button to automatically close the awning. If the button
is released the awning will stop. Keep the button depressed until the awning is fully
retracted, then release.
IMPORTANT:
In the event that the awning will not extend or retract, the awning fuse may be blown. The
fuse is located in the front leg of the awning. Various circumstances can cause the awning
fuse to blow: such as a bind in the awning fabric or a bent arm from a windstorm. When this
happens, one side could come out freely and the other isn't free.
The awning uses a 2A buss fuse.

INSTALLING A HITcH BELoW THE BUMPER

There are tabs on the chassis for a bolt-on hitch that is available from Vanleigh. It will have a
2" receiver and has a tongue weight of 350 lbs. Contact Lippert for pricing.
2 1 8
e XT eri or f eaT ure s
As an extra safety precaution, visually verify that the awning is fully
closed.

Figure 129. Awning Fuse

VA N L E I G H B E A c o N