Leveling System (Hydraulic) - Tiffin Motorhomes Allegro Bus 2011 Owner's Manual

Table of Contents

Advertisement

The ladder is typically used to permit easy access to the roof for routine maintenance and periodic inspections.
The ladder comes in two sections; the upper section is attached to the motor home; while the lower section is
removable and must be stored after use. When attaching the lower part of that ladder to its upper part, be sure
that the ball-lock pin is securely fastened through the locking device to secure the ladder assembly.
Do not exceed the maximum rating of the ladder (i.e., 200-pound load limit).
Do not attempt to walk on the roof either while it is wet or when condensation is
present from the air-conditioning system, as that surface would be quite slippery.

Leveling System (Hydraulic)

If the vehicle is equipped with a slide-out, DO NOT OPERATE any room extension until
the leveling and stabilizing procedure has been properly completed. DO NOT RETRACT
the leveling system until the slide-out room has been retracted. NEVER operate the
HYDRAULIC LEVELING SYSTEM
The Allegro Bus is equipped with hydraulic-leveling jacks. These jacks work in pairs: Front, right side, left side,
and rear. Before extending these jacks, the engine must be "off," the ignition switch must be in the
"ACC" position, and the transmission must be in "park." The parking brake needs to be set and the
tires blocked securely; then the leveling jacks can be activated.
DO NOT LIFT the wheels of the motor home off the ground when leveling—if done, the
motor home can tilt forwards or backwards when supported only by the leveling jacks.
Never use the jacks to lift the motor home off the ground to change the tires or
perform any under-chassis maintenance—these jacks are not meant for this type of
E X T E R I O R
Warning
Warning
leveling system when the slide-out is extended.
Caution
F E A T U R E S
9-3

Advertisement

Table of Contents
loading

Table of Contents