•
Inspect exhaust tube for any obstructions.
•
Check furnace fuse in fuse panel. Replace if necessary.
•
Check that the return air grill is unobstructed. Remove anything that is stored in the
furnace compartment that could block airflow.
•
Check that all heat outlet registers are open and unobstructed.
•
Make sure 12V power is going to the outlet.
•
Contact Vanleigh Tech Support if the problem persists.
INTERIoR LIGHTS
Lights flicker
•
Loose connection at Harness/Light. Have connection checked by an authorized service
center.
•
Converter is overheating. Open the cover to cool down and reduce the load by turning
off some 12V lights.
Lights dim or are half bright
NoTE:
The lights are on a dimmer switch. Brighten the lights using the dimmer switch.
•
Low battery voltage. Check battery condition and recharge if necessary.
•
Possible converter malfunction. Have the converter checked by an authorized service
center.
•
Possible loss of ground. Check for loose wire connection.
JAcKS/LEVELING SYSTEM
No power to control panel on basement door
•
Make sure your battery has 12V charge.
•
Check the connection at the control panel and make sure it hasn't come unplugged.
•
Check the 10A fuse located behind the hydraulic pump (if blown replace it).
•
Call Tech Support if no resolution.
VA N L E I G H B E A c o N
VA N L E I G H B E A c o N
2 39
2 39
2 3 9
2 3 9