Table of Contents
Advertisement
Installation Guide Linear Rotary Motors
4.3 Mounting the Load on the Shaft
The assembly and disassembly of the load mass must not take place in the mechanical end
stops of the linear movement. An external support must be used.
4.3.1 Feather Key
The load mass can be mounted via a feather key. For this purpose, a slot is machined into the end of the
shaft.
Feather key slot
Linear rotary shaft
Ordering information
Item
Parallel keys deep
pattern
4.3.2
Shaft-Hub Clamping
4.4 Material Data
Component
Linear rotary shaft
Front flange (Rotary motor)
Housing (Rotary motor)
Page 12 / 48
Description
face side domed / DIN 6885 A / ISO R773
4x4x10, steel C 45 K, plain
PR01-52
Front flange (rotary motor)
The shaft-hub clamping is a non-positive
connection which is produced by means of two
conical rings.
The use of drivers or the production of grooves is
completely eliminated. The suitable shaft-hub
clamping type can be ordered from LinMot.
Mounting instructions and ordering information can
be found in the "Accessories" chapter.
Material
Quenched and tempered steel C60 (1.0601)
Hard anodized aluminium (3.3206)
Hard anodized aluminium (3.3206)
ENG
Item-No.
0230-0269
NTI AG / LinMot
Advertisement
Table of Contents
