Table of Contents
Advertisement
Installation Guide Linear Motors
Mounting the stator
The motor is aligned flat and screwed to the base using the threaded holes on the underside of the motor.
The positions of the threaded holes are shown in section 8 «Dimensions».
Max. tightening torque must be observed.
Mounting the payload to the slider
The load is mounted as a fixed bearing using spherical washers and conical seats (see the section «Slider
mounting kits»).
To avoid shear force on slider and wear on stator, the payload has to be beared by a linear
guide.
Page 8 / 28
Thread
M5
P01-37S-HP-SSCP
Checking the installed direction of slider
After the installation, the front end of the slider
is located at the opposite side of the stator from
the cable connector or cable exit.
Max. torque for screw
3.5 Nm
ENG
NTI AG / LinMot
Advertisement
Table of Contents
