Table of Contents
Advertisement
Installation Guide Linear Rotary Motors
8.3 Maintenance Instructions
8.3.1 Cleaning the visible Part of the Slider
Page 38 / 48
1. Remove additional parts.
Remove any mounted wiper (shown),
MagSpring or brake flange.
2. Pull the slider out of the stator as far as
possible.
Large magnetic attraction forces
(observe warning notice, section 2)! If
necessary, cover nearby iron constructions
with non-magnetic material (e.g. wood).
3. Clean the slider.
Clean the visible end of the slider with a clean
and soft cloth. Ideally use LU06 cleaning
spray (alternatively methylated spirit or
alcohol) for cleaning.
4. Grease the slider.
Grease the end of the slider with approx. 4 g
grease LU02 (for ordering information see
chapter 8.5) Only a light grease film should be
present on the slider surface.
Make sure that the specified grease
quantity is observed. Overgreasing
can lead to resinification of the grease,
especially at higher operating
temperatures!
PR01-52
ENG
NTI AG / LinMot
Advertisement
Table of Contents
