Table of Contents
Advertisement
Installation Guide Linear Motors
Slider front end:
M10 thread + cut-in
Mounting the stator
The motor is levelled and fixed to the ground using the holes in the flange foot.
The hole pattern is shown in section 9.1 "Stator Dimensions".
Mounting the payload to the slider
The load is mounted as a fixed bearing using spherical washers and conical seats (see the section 6.3).
•
To avoid shear force on slider and wear on stator, the payload has to be beared by a
linear guide.
•
Slider back end (M8 internal thread) should not be used for load mounting.
Page 8 / 44
Slider back end:
M8 thread
P10-70-SSC / P10-70-SSC-Dxx
Insert the slider in the defined direction (see
Assembly step 5.).
Large magnetic attraction forces
(Observe warning notice from page 5)!
If necessary, cover obvious iron constructions
with non-magnetic material (e.g. wood).
Checking the installed direction of slider
After the installation, the front end of the slider
with M 10 thread and cut-in is located at the
opposite side of the stator from the cable exit.
Slider back end should not be used for
load mounting!
ENG
NTI AG / LinMot
Advertisement
Table of Contents
