Direction Of Force Magspring Kit - LinMot PR01-52 Series Installation Manual

Installation Guide Linear Rotary Motors

7.8.3 Direction of Force MagSpring Kit

The direction of force changes depending on the installation direction of the MagSpring slider. This means
that the MagSpring can pull or push out the motor shaft. The direction of force for the pre-assembled
MagSpring can be selected using the part numbers listed below.
Push movement MagSpring
Ordering information
Item
MagSpring push
MagSpring pull
Do not drive into the internal mechanical stops!
Basically, it must be ensured that the linear motor does not move to the lower or upper
internal stop during operation under any circumstances. In particular, when using a
MagSpring, it must be ensured that the MagSpring does not 'fling' the rotary axis into the
internal mechanical stops under any circumstances. A mechanical stop ring, for example,
mounted on the linear rotary shaft, can prevent this.
NTI AG / LinMot
Description
Linear-Rotary Motor MagSpring force direction: push
Linear-Rotary Motor MagSpring force direction: pull (default)
Pull movement MagSpring
PR01-52
ENG
Item-No.
0140-0005
0140-0006
Page 29 / 48