Table of Contents
Advertisement
Installation Guide Linear Rotary Motors
4.3 Mounting the Load on the Shaft
The load mass is mounted by a shaft-hub clamping. The shaft-hub clamping is a non-positive connection
which is produced by means of two conical rings. The use of drivers or the production of grooves is
completely eliminated. The suitable shaft-hub clamping type can be ordered from LinMot. Mounting
instructions and ordering information can be found in the "Accessories" chapter.
4.4 Material Data
Different materials are used depending on the design of the linear rotary motor.
4.4.1 Standard Design
Component
Linear Rotary Shaft
Front Flange
Linear Ball Bearing
Wiper
Housing Linear Rotary Motor
4.4.2 Stainless Steel Front SSC
Component
Linear Rotary Shaft
Front Flange
Linear Ball Bearing
Wiper
Housing Linear Rotary Motor
Page 12 / 41
Material
Quenched and tempered steel 1.0601 / C60
Stainless Steel 1.4305
Steel
NBR
Hard anodized aluminium 3.3206
Material
Stainless Steel 1.4112
Stainless Steel 1.4404
Stainless Steel
NBR 80 FDA
Hard anodized aluminium 3.3206
PR02-70
ENG
NTI AG / LinMot
Advertisement
Table of Contents
