Table of Contents
Advertisement
Installation Guide Linear Rotary Motors
4.3 Mounting the Load on the Shaft
The load mass is mounted by a shaft-hub clamping. The shaft-hub clamping is a non-positive connection
which is produced by means of two conical rings. The use of drivers or the production of grooves is
completely eliminated. The suitable shaft-hub clamping type can be ordered from LinMot. Mounting
instructions and ordering information can be found in the "Accessories" chapter.
4.4 Material Data
Component
Linear Rotary Shaft
Front Flange
Linear Ball Bearing
Wiper
Housing Linear Rotary Motor
NTI AG / LinMot
Material
Quenched and tempered steel 1.0601 / C60
Stainless Steel 1.4305
Steel
NBR
Hard anodized aluminium 3.3206
PR02-88
ENG
Page 11 / 34
Advertisement
Table of Contents
