Cleaning The Inside Of The Linear Motor - LinMot PR01-52 Series Installation Manual

Installation Guide Linear Rotary Motors
Linear rotary motors may have grease nipples, which are used by LinMot for initial
lubrication. Linear rotary motors may have grease nipples which are required by LinMot for
initial factory lubrication. The customer is prohibited from using the grease nipples for
cyclical maintenance. For proper maintenance, refer to the following sections in this chapter.

8.3.2 Cleaning the Inside of the Linear Motor

•
The following work may only be carried out by NTI AG / LinMot GmbH or companies
qualified by LinMot.
•
The linear rotary motor may only be opened by trained personnel.
•
The motor may only be opened after the previous chapter "Cleaning the visible part of
the slider" has not produced the desired effect.
•
Opening of the motor by unqualified personnel will result in loss of warranty.
A full maintenance of the PR01 linear rotary motor can be ordered from NTI AG / LinMot (recommended).
Item
Maintenance: PR01-52/PR02-52
Cleaning, replacement wear parts
The motor shown below is representative for all linear rotary motors of the PR01 family.
Depending on the type of motor and revision, there are different mechanical versions.
It is the responsibility of trained personnel to handle the different versions accordingly. This
applies to disassembly and assembly.
1: Linear rotary shaft
2: Stator (Rotary Motor)
3: Stator (Linear Motor)
4: Slider (Linear Motor)
NTI AG / LinMot
5. Remove further dirt particles.
Description
Maintenance Linear Rotary Motors
5: Washer
6: Mounting screws linear rotary motor
7: End part stator (Linear Motor)
8: O-Ring
PR01-52
Move the slider of the linear motor or the
entire linear rotary shaft axially forwards and
backwards to remove further possible dirt
particles from the stator of the linear motor. If
necessary, repeat steps 1-4 of the
maintenance instructions until no more dirt is
visible on the slider. Make sure that only a
light film of grease remains on the slider.
9: Adapter part
ENG
Item-No.
r156
Page 39 / 48