Connection To Hpe Status; Network Details; Viewing Health Summary Information - HPE ProLiant e910 User And Maintenance Manual

Connection to HPE status

This section shows the remote support registration status for supported servers.
The possible status values follow:
• Registered to Remote Support—The server is registered.
• Registration incomplete—The server is registered for Insight Online direct connect remote support, but step 2 of the
registration process is incomplete.
• Not registered—The server is not registered.
• Unable to retrieve the HPE Remote Support information—The registration status could not be determined.
Remote Support Registration Error—A remote support connection error occurred.
•
You can click the status value to navigate to the remote support registration page.

Network details

Active Network Interface
The following details are displayed for the active network interface:
• Active network interface name—The name of the active iLO network interface ( iLO Dedicated Network Port or iLO
Shared Network Port).
To navigate to the Network Summary page, click the network interface name link.
IP Address—The iLO subsystem IP Address. If an IPv4 address is not configured, this value is not displayed.
•
• Link-Local IPv6 Address—The iLO subsystem SLAAC link-local address.
• iLO Hostname—The fully qualified network name assigned to the iLO subsystem. By default, the hostname is ILO,
followed by the system serial number and the current domain name. This value is used for the network name and must
be unique.
iLO Virtual NIC
The iLO Virtual NIC section displays the IP address to use when you connect to iLO through the Virtual NIC.
To navigate to the Access Settings page, where you can enable this feature, click iLO Virtual NIC.

Viewing health summary information

The Health Summary page displays the status of monitored subsystems and devices. Depending on the server configuration,
the information on this page varies.
If the server is powered off, the system health information on this page is current as of the last power off. Health information is
updated only when the server is powered on and POST is complete.
Procedure
1. Click System Information in the navigation tree.
2. (Optional) To sort by a table column, click the column heading.
To change the sort order to ascending or descending, click the column heading again or click the arrow icon next to the
column heading.
3. (Optional) To navigate to a related page for supported subsystem and device types, click the name of a value in the
Subsystems and Devices list.
Using HPE iLO 5 73