Configuring Ilo Service Settings - HPE ProLiant e910 User And Maintenance Manual

If you customize the SNMP Port value, some SNMP clients might not work correctly with iLO unless those clients support
the use of a nonstandard SNMP port.
SNMP Trap Port
Sets the SNMP trap port. The industry-standard (default) SNMP trap port is 162 for SNMP alerts (or traps).
If you customize the SNMP Trap Port , some SNMP monitoring applications might not work correctly with iLO unless
those applications support the use of a nonstandard SNMP trap port.
To use SNMP v3 with HPE SIM 7.2 or later, change the SNMP Trap Port value to 50005.
IPMI/DCMI over LAN
Allows you to send industry-standard IPMI and DCMI commands over the LAN.
This setting is disabled by default.
When IPMI/DCMI over LAN is disabled, iLO disables IPMI/DCMI over the LAN. Server-side IPMI/DCMI applications are still
functional when this feature is disabled.
When IPMI/DCMI over LAN is enabled, iLO allows you to use a client-side application to send IPMI/DCMI commands over
the LAN.
When IPMI/DCMI over LAN is disabled, the configured IPMI/DCMI over LAN Port is not detected in a security audit that
uses a port scanner to scan for security vulnerabilities.
IPMI/DCMI over LAN Port
Sets the IPMI/DCMI port number. The default value is 623.

Configuring iLO service settings

The TCP/IP ports used by iLO are configurable, which enables compliance with site requirements and security initiatives for
port settings. These settings do not affect the host system. The range of valid port values in iLO is from 1 to 65535. If you
enter the number of a port that is in use, iLO prompts you to enter a different value.
You can enable or disable iLO features in the Service section of the Access Settings page.
Changing these settings usually requires configuration of the web browser used for standard and SSL communication. When
these settings are changed, an iLO reset is required to activate the changes.
Prerequisites
Configure iLO Settings privilege
Procedure
1. Click Security in the navigation tree.
The Access Settings page is displayed.
2. Update the service settings as needed.
When you disable a service setting, iLO notifies you that the features that depend on the service setting will be unavailable
if you apply the changes.
3. Click Apply.
iLO prompts you to confirm that you want to apply the changes and reset iLO.
4. To apply the changes and reset iLO now, click Yes, apply and reset.
It might take several minutes before you can re-establish a connection.
Setting up iLO 61