T10FS
4.9 Aligning the stator (speed measuring system)
The stator can be mounted in any position (for example, "upside down"
installation is possible).
For measuring mode to operate perfectly, the speed sensor (pole ring/slotted
disc) of the speed measuring system must be positioned at a defined point on
the sensor.
NOTE
To attach the stator, we recommend the use of M6 screws with plain
washers (width of oblong hole, 9 mm). This size of screw guarantees the
necessary travel for alignment (see also note on page 18).
4.9.1 Magnetic speed measuring system
NOTE
With the magnetic speed measuring system, the pole ring of the rotor and
the sensor head of the stator are matched to each other. To enable the
specified pulse quality to be maintained, torque transducer components
from different consignments must not be interchanged. Therefore,
compare the identification numbers of rotor and stator before
installation!
A0785 14.0 en
27
HBM