Xilinx KCU116 User Manual page 80

X-Ref Target - Figure 3-32
On first use of the SCUI, go to the FMC > Set VADJ > Boot-up tab and click USE FMC
EEPROM Voltage. The SCUI buttons are grayed out during command execution and return
to their original appearance when ready to accept a new command. See
See the KCU116 System Controller Tutorial (XTP465)
Install and Board Setup Tutorial (XTP464)
using the system controller utility.
For additional information on the Zynq-7000 SoC device I
SoC Overview Data Sheet (DS190)
Manual (UG585)
KCU116 Board User Guide
UG1239 (v1.2) September 28, 2018
Figure 3‐32: KCU116 SCUI
[Ref 2]
[Ref 12].
www.xilinx.com
Chapter 3: Board Component Descriptions
[Ref 16] and the KCU116 Software
[Ref 17] for more information on installing and
2
C controller, see the Zynq-7000
and the Zynq-7000 SoC Technical Reference
X18583-050417
Figure 3-32.
80
Send Feedback