Safety Precautions - Oracle Server X6-2 Installation Manual

Safety Precautions

This section describes safety precautions you must follow when installing the server into a rack.
Caution -
and moving the rack to a new location, verify that the leveling feet are up before moving the
rack.
Caution -
beginning an installation.
Caution -
the rack will not become top-heavy and tip over. Deploy your rack's anti-tilt bar to prevent the
rack from tipping during equipment installation.
Caution -
or multi-unit rack assembly, the operating ambient temperature of the rack environment
might be greater than room ambient temperature. Therefore, consideration should be given to
installing the equipment in an environment compatible with the maximum ambient temperature
(Tma) specified for the server. For server environmental requirements, see
Requirements" on page
Caution -
amount of airflow required for safe operation of the equipment is not compromised.
Caution -
hazardous condition is not created due to uneven mechanical loading.
Caution -
equipment to the supply circuit and the effect that overloading of the circuits might have on
over-current protection and supply wiring. Appropriate consideration of equipment nameplate
power ratings should be used when addressing this concern.
Caution -
maintained. Particular attention should be given to supply connections other than direct
connections to the branch circuit (for example, use of power strips).
Leveling feet position: When unpacking at the installation site, or when repackaging
Stabilize rack: Deploy the anti-tilt bar or legs on the equipment rack before
Equipment loading: Always load equipment into a rack from the bottom up so that
Elevated operating ambient temperature: If the server is installed in a closed
20.
Reduced airflow: Installation of the equipment in a rack should be such that the
Mechanical loading: Mounting of the equipment in the rack should be such that a
Circuit overloading: Consideration should be given to the connection of the
Reliable earthing: Reliable earthing of rackmounted equipment should be
Safety Precautions
"Environmental
Installing the Server Into a Rack 39