Oracle Server X6-2 Installation Manual page 86

Modify Oracle ILOM SP Network Settings
From the CLI:
■
a.
b.
c.
Note -
properties are set to enabled. By default, Oracle ILOM is factory-configured with network
settings enabled for a dual stack (IPv4 and IPv6) network connection. If the IPv4 State property
is enabled (SP/network state=enabled), and the IPv6 State property is disabled (SP/network
state=disabled), Oracle ILOM supports an IPv4-only network connection.
d.
Note -
changes. To log back in to Oracle ILOM, use the newly assigned service processor IP address.
86 Oracle Server X6-2 Installation Guide • July 2020
To view the assigned IPv4 and IPv6 network settings on the SP, perform
the following:
For IPv4, type: show /SP/network
For IPv6, type: show /SP/network/ipv6
To view the descriptions about each IPv4 and IPv6 network property,
perform the following:
For IPv4, type: help /SP/network
For IPv6, type: help /SP/network/ipv6
To modify the IPv4 and IPv6 network properties on the SP, issue the set
command.
IPv4 Example:
set /SP/network state=enabled|disabled pendingipdiscovery=static|dhcp
pendingipaddress=value pendingipgateway=value pendingipnetmask=value
IPv6 Example:
set /SP/network/ipv6 state=enabled|disabled pending_static_ipaddress=
value/subnet_mask_value pending_static_ipgatewayaddress= value
A dual-stack network connection is enabled when both the IPv4 and IPv6 State
To commit the IPv4 and IPv6 pending network changes in Oracle ILOM,
type:
set /SP/network commitpending=true
All user sessions on the SP are terminated upon committing the IP network property