Oracle Server X6-2 Installation Manual page 105

Unlike in Legacy Boot Mode, in UEFI Boot Mode, you do not need to make the drive
Note -
bootable. In UEFI boot mode, the operating system installation procedure makes the drive
bootable.
Configure the server for a one-time boot to BIOS.
1.
a. Access the Oracle ILOM web interface.
b. Navigate to Host Management → Host Control.
c. Select BIOS from the drop-down list, and then select Save.
The server is configured to boot to BIOS on the next boot.
2. From the Summary window, select Remote Console → Launch and answer the
dialogs.
The remote console screen appears.
3. Power on or reset the server.
For example, to reset the server:
From the local server, press the Power button (approximately 1 second) on the front panel
■
of the server to power off the server, and then press the Power button again to power on the
server.
From the Oracle ILOM web interface, select Host Management → Power Control, and
■
then select Power On from the Select Action list box. Click Save, and then click OK.
From the Oracle ILOM CLI, type:
■
4. When prompted in the BIOS screen, press the F2 function key (Ctrl+E from a
serial connection) to launch the BIOS Setup Utility.
The BIOS Setup Utility appears.
The steps and screens in this procedure are examples. What you actually see might differ
Note -
depending on your system's equipment and configuration.
reset /System
Configuring Storage Drives for Operating System Installation
Configure RAID in UEFI Boot Mode
105