Mark The Rackmount Location - Oracle Server X6-2 Installation Manual

the front of the chassis until the mounting bracket clip locks into place with an
audible click.
Verify that the rear locating pin has engaged the mounting bracket clip.
3.
Repeat Step 1
4.
other side of the server.
Related Information
"Mark the Rackmount Location" on page 43
■
"Attach Tool-less Slide-Rail Assemblies" on page 47
■

Mark the Rackmount Location

Identify the location in the rack where you want to place the server. The server requires one
rack unit (1U). Use the rackmount installation card to identify the correct mounting holes for
the slide-rails.
Load the rack from bottom to top.
Note -
1. Ensure that there is at least 1 rack unit (1U) of vertical space in the rack cabinet
to install the server.
See "Rack Requirements" on page
2. Place the rackmount installation card against the front rails.
through Step 3 to install the remaining mounting bracket on the
38.
Mark the Rackmount Location
Installing the Server Into a Rack 43