Table of Contents
Advertisement
Determine Correct Rackmount Hardware
Determine Correct Rackmount Hardware
Determine the hardware needed for your rack installation.
Rack Type
Square hole
Round hole (10-32) with corner bezel
Round hole (M6) with corner bezel
Round hole (10-32) inside installation
Round hole (M6) inside installation
Note -
server.
Related Information
"Rackmount Kit (Part number 7069640)" on page 32
■
"Rackmount Kit (Part number 350-1662-02)" on page 34
■
"Rack Compatibility " on page 30
■
"Mark the Rackmounting Location" on page 36
■
"Install the Rackmount Hardware" on page 37
■
Mark the Rackmounting Location
Use the Rack Buddy template to identify the correct mounting holes for the shelf rails.
Note -
1.
Ensure that there is enough vertical space in the rack to install the server.
Place the Rack Buddy template against the front rails.
2.
36
SPARC T5-4 Server Installation Guide • July 2015
Some of the fastener bags that are included in the kit are not required to install this
Load the rack from bottom to top.
Fastener Bags Required
SCREW, SEMS, M6 X 16
CAGE NUTS, M6
SCREW, FLAT HEAD, M4 X 10
SCREW, SEMS, 10-32 X 10
SCREW, FLAT HEAD, M4 X 10
SCREW, SEMS, M6 X 12
SCREW, FLAT HEAD, M4 X 10
SCREW, SHOULDER, 10-32
SCREW, FLAT HEAD, M4 X 10
SCREW, SEMS, M6 X 12
SCREW, FLAT HEAD, M4 X 10
Advertisement
Table of Contents
