Mode 5 — Reset to Factory Defaults
Activation
Hold down the Reset button for approximately 9 seconds until the Reset LED blinks three
times (at 3, 6, and 9 seconds). Then release and press the Reset button momentarily (less than
1 second) within 1 second.
NOTE:
Result
This mode performs a complete reset to factory defaults (except the firmware). It does everything
that mode 4 does and, in addition:
•
•
•
•
NOTES:
Purpose and Notes
This mode is useful if you want to start over with configuration and uploading, and also to replace
events.
Nothing happens if the momentary press does not occur within 1 second.
Removes button and touchpanel configurations.
Resets all IP options
Removes all scheduling options.
Removes and clears all files from the touchpanel
The factory configured passwords for all accounts on this device have been set to the
•
device serial number. Passwords are case sensitive.
If the device is reset to default settings, the password is the default password
•
configuration. The default password is extron.
TLP 1000MV and TLP 1000TV • Reset Modes
51