Wall Mounting The Tlp 1000Mv; Wall Mounting The Tlp 1000Mv Directly Into The Wall - Extron electronics TouchLink TLP 1000MV User Manual

Wall Mounting the TLP 1000MV

The TLP 1000MV can be mounted in the wall or through furniture.

Wall Mounting the TLP 1000MV Directly into the Wall

CAUTION:
ATTENTION : Risque d'incendie — Ne pas installer le TLP 1000MV dans un mur
To mount the TLP 1000MV directly into a wall, follow these steps.
1.
2.
3.
4.
5.
6.
7.
8.
Fire Hazard — Do not install the TLP 1000MV in a fire resistant rated wall or
partition assembly.
résistant au feu ou une cloison.
Determine the best location for the TLP 1000MV.
Use the template provided to mark the wall and then cut a hole 10.22 inches (25.96 cm)
wide x 7.16 inches (18.2 cm) high.
Unpack the TLP 1000MV and remove the bezel, using the Extron removal tool.
Ensure all the locking arms are flush with the unit and check that the TLP 1000MV can fit
into the hole. If necessary, use a rasp or a coarse file to enlarge the hole.
Run the network cable and video connectors inside the wall to the hole, leaving enough
slack in the cables to connect them to the back of the TLP 1000MV.
Plug the cables into the rear panel connectors (see
and Connections on page 6).
Connect the LAN port to the network with a straight-through cable, providing both a
•
network connection and power from a power injector.
Connect an S-video or composite video source to the RJ-45 MTP input.
•
Optional: Extron recommends using the power injector provided. However, you may use
the LAN port only as a network connection and connect a 12 VDC, 1.0 A power supply (not
provided) to the 2-pole captive screw power input.
ATTENTION:
Do not power on the touchpanels or control processors until you have read the
•
Attention on page 10
Ne branchez pas les écrans tactiles ou les contrôleurs avant d'avoir lu les
•
en garde page 10 (source d'alimentation 12 VCC) ou
Push excess cables into the wall cavity.
Ensure the five locking arms (three at the top and two at the bottom) are flush with the top
and bottom of the TLP 1000MV and fit the touchpanel into the hole.
TLP 1000MV Rear Panel Features
(12 VDC power supply) or on
TLP 1000MV and TLP 1000TV • Mounting
page 8 (power injector).
mises
page 8 (injecteur PoE).
43