Reset Modes - Extron electronics TouchLink TLP 700MV User Manual

Reset Modes

The TLP 700MV and TLP 700TV have four reset modes that correspond to four of the
five reset modes for the IP Link controllers. The modes are initiated by pressing the Reset
button.
To access the Reset button on the TLP 700MV, remove the bezel. See figure 3 to locate the
Reset button on the TLP
the bezel, which cannot be removed. It is necessary to use a pen or paper clip to press it.
See figure 6 to locate the
Mode Activation
1
Hold down the recessed
while applying power to the touchpanel.
NOTE:
performed, update the touchpanel
firmware to the latest version. Do
not operate the firmware version
that results from this mode
reset. To use the factory default
firmware, reload that version.
See page 17 for details about
uploading firmware.
3
Hold down the
approximately 3 seconds until the
Reset
LED blinks once. Then release
and press
than 1 second) within 1 second.
4
Hold down the
approximately 6 seconds until the
Reset
LED blinks twice (at 3 seconds
and 6 seconds). Then release and
Reset
press
1 second) within 1 second.
NOTE:
momentary press does not occur
within 1 second.
5
Hold down the
approximately 9 seconds until the
Reset
LED blinks three times (at 3,
6, and 9 seconds). Then release and
Reset
press
1 second) within 1 second.
NOTE:
momentary press does not occur
within 1 second.
700MV. The Reset button on the TLP 700TV is recessed behind
Reset button on the
TLP 700MV and TLP 700TV Reset Mode Summary
Result
Reset The touchpanel reverts to the factory default
button
firmware. Event scripting does not start if the
touchpanel is powered on in this mode. All user
files and settings (GUI, adjustments, IP settings)
After a mode 1 reset is
are maintained.
Reset This mode turns events on or off.
button for
Reset
momentarily (less
Reset This mode:
button for
momentarily (less than
Nothing happens if the
Reset This mode performs a complete reset to factory
button for
defaults (except the firmware). It does everything
that mode 4 does and, in addition:
momentarily (less than
Nothing happens if the
TLP 700TV.
NOTE:
If you do not want to update firmware
or you performed a mode 1 reset by
mistake, cycle power to the touchpanel
to return to the firmware version that was
running before the mode 1 reset. Use the
0Q SIS command to confirm that the factory
default firmware is no longer running (look
for asterisks following the version number).
NOTE:
Nothing happens if the momentary
press does not occur within 1 second.
Enables ARP capability.
•
Resets the IP address to the factory default
•
(192.168.254.254).
Resets the subnet to the factory default.
•
Resets the gateway address to the factory
•
default.
Turns port mapping back to the factory default.
•
• Turns DHCP off.
• Turns events off.
Removes button and touchpanel
•
configurations.
Resets all IP options
•
Removes all scheduling options.
•
Removes and clears all files from the
•
touchpanel
TLP 700MV and TLP 700TV • Reset Modes
Purpose and Notes
This mode reverts to the
factory default firmware
version if incompatibility
issues arise with
user-loaded firmware.
NOTE:
User-defined Web
pages may not
work correctly
with an earlier
version of the
firmware.
This mode is useful for
troubleshooting.
This mode enables
you to set IP address
information, using ARP
and the MAC address.
This mode is useful if
you want to start over
with configuration and
uploading, and also to
replace events.
42