Reset All Ip Settings; Reset To Factory Defaults - Extron electronics TouchLink TLP Pro 1020 Series User Manual

Purpose and Notes
Use this mode to temporarily boot up the unit with factory installed firmware for a single power
cycle in the event that a firmware update has failed or if incompatibility issues arise with user-
loaded firmware.
NOTE:
version.

Reset All IP Settings

Activation
To reset all IP settings:
1.
Hold down the Reset button for about 6 seconds until the Power LED blinks twice (once at 3
seconds and again at 6 seconds).
2.
Release and press Reset momentarily (for <1 second) within 1 second. Nothing happens if
the momentary press does not occur within 1 second.
Result
Reset All IP Settings mode:
Sets the IP address back to factory default (192.168.254.251).
z
Sets the subnet back to factory default (255.255.255.0).
z
Sets the default gateway address to the factory default (0.0.0.0).
z
Sets all other IP settings, addresses, and domain and host names back to factory default.
z
Turns DHCP off.
z
Purpose and Notes
Reset All IP Settings mode enables you to reset IP settings to factory defaults.

Reset to Factory Defaults

Activation
To reset the unit to all factory default settings:
1.
Hold down the Reset button for about 9 seconds until the Power LED blinks three times
(once at 3 seconds, again at 6 seconds, and again at 9 seconds).
2.
Release and press Reset momentarily (for <1 second) within 1 second. Nothing happens if
the momentary press does not occur within 1 second.
Result
Reset to Factory Defaults mode performs a complete reset to factory defaults (except the
firmware).
Does everything Reset All IP Settings mode does.
z
Removes touchpanel user interface layout and configurations.
z
Purpose and Notes
Reset to Factory Defaults mode is useful if you want to start over with configuration and
uploading.
User-defined web pages may not work correctly if you are using an earlier firmware
TLP Pro 720 Series and TLP Pro 1020 Series • Reference Material 31