Tlp 1000Mv Rear Panel Features And Connections - Extron electronics TouchLink TLP 1000MV User Manual

TLP 1000MV Rear Panel Features and Connections

Figure 5.
A
B
C
D
A
B
A A A B B B
TLP 1000MV Rear Panel Features
MTP signal adjustment controls
(see page 6)
MTP input
Network and Power over Ethernet connector
Power connector (see page 9)
MTP signal adjustment controls — three MTP signal adjustments are available for
S-video luminance gain (VID/Y), S-video chrominance gain (C), and sharpness (S). For
composite video signals, the gain is controlled by the VID/Y adjustment.
MTP input — connect a twisted pair cable, terminated with an RJ-45 connector, to provide
video and audio input from an Extron MTP transmitter.
ATTENTION:
The right RJ-45 connector on the back of the TLP 1000MV (with the yellow and
•
green LEDs) must be connected to a network. The left RJ-45 connector must be
connected to an Extron MTP Transmitter. The MTP and LAN use different voltages;
switching the connectors will damage the touchpanel.
Le connecteur RJ-45 droit situé au dos du TLP 1000MV (avec des LED jaunes
•
et vertes) doit être connecté à un réseau. Le connecteur RJ-45 gauche doit être
connecté à un émetteur MTP Extron. Le MTP et le LAN utilisent des tensions
différentes; permuter les connections risque d'endommager l'écran tactile.
C C C D D D
(see page 6)
(see page 7)
TLP 1000MV and TLP 1000TV • Panel Features 6