Table of Contents
Advertisement
R0E436640CPE00 User's Manual
5. Troubleshooting
This chapter describes how to troubleshoot when this product does not work properly.
5.1 Flowchart to Remedy the Troubles
Figure 5.1 shows the flowchart to remedy the troubles from when power to the emulator is activated until the emulator
debugger starts up. Check this while the user system is disconnected. For the latest FAQs visit the Renesas Tools Homepage.
Turning on emulator
Init dialog box of emulator
debugger displayed
MCU Setting dialog box of
Program window of emulator
debugger displayed
Emulator debugger startup completed
Figure 5.1 Flowchart to remedy the troubles
REJ10J0918-0300 Rev.3.00 February 15, 2007
http://www.renesas.com/tools
Upper panel LED
of emulator
Normal
Normal
emulator debugger
Normal
Normal
Not normal
1. Check the connection of power supply cable.
See "2.4 Connecting the Power Supply for the Emulator "
(page 23).
2. Check that the power is properly supplied to the use system.
"
See
2.6 Turning ON the Power
Not normal/Error displayed
1. Check the operating environment etc. of the emulator
debugger.
'
See the user
s manual (online manual) of the emulator
debugger.
2. Reinstall the emulator debugger.
Not normal/Error displayed
"
See
5.2.2 MCU Setting Dialog Box Does Not Appear at
"
Emulator Debugger Startup
(page 97).
Error displayed
"
See
5.2.3 Errors Occur at Emulator Debugger Startup
(page 97).
5. Troubleshooting
"
(page 25).
"
Page 95 of 102
Advertisement
Table of Contents
