Renesas R0E436640CPE00 User Manual page 28

R0E436640CPE00 User's Manual
Figure 2.9 Target status LEDs display when the emulator starts up normally (when user system connected)
Note on the Target Status CLOCK LED:
If the LED is not turned on, check the following.
(1) After powering on the emulator (before starting up the emulator debugger):
Make sure that the oscillator circuit board is properly installed in the emulator and it is oscillating normally.
(2) After the emulator debugger is started up (after the Init dialog box settings are completed):
Make sure that the oscillator selected in the Init dialog box is oscillating normally.
REJ10J0918-0300 Rev.3.00 February 15, 2007
When the user system connected:
If the POWER LED does not light when
the JP1 of the R0E43664EPBM0 is set
to INT POWER, shut off the system
and check that the setting of the jumper
switches and the power is properly
supplied to the user system.
: ON
: OFF
IMPORTANT
POWER LED3
CLOCK LED4
RESET LED5
RUN LED6
2. Setup
Page 28 of 102