Trace Window - Renesas R0E436640CPE00 User Manual

R0E436640CPE00 User's Manual

3.7 Trace Window

(1) Trace window
1) Opening the trace window
REJ10J0918-0300 Rev.3.00 February 15, 2007
3. Usage (Emulator Debugger)
Trace window
Clicking this button opens the trace window.
Or you can select "Trace" from "Trace" of "View" menu for
the same effect.
Trace window
The trace window is used to show the results of real-time
trace measurements. It has the following four display
modes:
- Bus mode
Bus information per cycle can be inspected. The contents
are displayed in order of execution paths.
- Disassemble mode
The execution paths of the executed instructions can be
inspected. The contents are displayed in order of execution
paths.
- Source mode
The execution paths of the source program can be
inspected.
Operating buttons of the tool bar can reference the
execution paths.
- Data access mode
Data read/write cycles can be inspected. In addition to the
data access information, the window can display the
source line information in combination with it.
The trace window shows the measurement result when a
real-time trace measurement has finished. The trace window
remains blank until the real-time trace measurement in
progress finishes.
Page 56 of 102