Mcu Setting Dialog Box Does Not Appear At Emulator Debugger Startup; Errors Occur At Emulator Debugger Startup - Renesas R0E436640CPE00 User Manual

R0E436640CPE00 User's Manual

5.2.2 MCU Setting Dialog Box Does Not Appear at Emulator Debugger Startup

Table 5.2 Checkpoints of errors at emulator debugger startup
Error
Communication error occurred.
Data was not sent to the target.
Not compact emulator.
Target MCU is in the reset state.
Target clock is stopped.

5.2.3 Errors Occur at Emulator Debugger Startup

Table 5.3 Checkpoints of errors at debugger startup
Error
Target MCU is uncontrollable.
REJ10J0918-0300 Rev.3.00 February 15, 2007
Check that the USB cable is connected properly.
See "2.5 Connecting the Host Machine" (page 24).
Check that an emulator other than the compact emulator (such as
PC4701, PC7501) is not connected.
Check that the reset pin of the user system is held high.
When the clock is supplied from an external oscillator, check that the
oscillator circuit in the user system is oscillating properly.
(1) Check that the IC socket etc. mounted on the user system is soldered
properly.
(2) Check that the connector is installed properly to the user system.
Checkpoint
Checkpoint
5. Troubleshooting
Page 97 of 102