Renesas R0E436640CPE00 User Manual page 42

R0E436640CPE00 User's Manual
3) Executing the self-check
Cancel
(2) Debugging Information tab
1) Referencing the compiler used and the object format
Cancel
REJ10J0918-0300 Rev.3.00 February 15, 2007
Help
Help
3. Usage (Emulator Debugger)
Executing the self-check
Enable this function when you want the emulator to be self-
checked at startup. Be sure to select the check box only
when you want the emulator to be self-checked at startup.
This function may be enabled in the following cases:
When you are using the emulator you have just
purchased
When you fail to download the firmware.
When you successfully download the firmware, but fail
to start up the emulator
When you want to confirm whether the emulator is
operating normally because, for example, the MCU runs
out of control or something is wrong with the trace
results
This function can be enabled only when you are starting up
the emulator debugger.
Specifying the compiler used and the object
format
Specify the compiler you are using and the format of the
object file output by the compiler.
- Compiler
Select the compiler you are using.
(By default, the C compiler from Renesas is selected.)
- Object Format
Select the format of the object file that is output by the
compiler you are using.
Specifying the method for storing debug
information
There are two methods for storing debug information: on-
memory method where data is held in memory and an on-
demand method where data is held in a temporary file.
- On Memory
This method helps to speed up processing if your
computer has sufficient memory.
- On Demand
This method helps to reduce the amount of memory
needed. To use this method, select the "On Demand"
check box.
Page 42 of 102