Led Display When The Emulator Starts Up Normally - Renesas R0E436640CPE00 User Manual

R0E436640CPE00 User's Manual

2.6.5 LED Display When the Emulator Starts Up Normally

After the emulator starts up, check the status of the LEDs to see whether the emulator operation is enabled or not. Figure 2.7
shows the positions of the emulator status LEDs.
System status LEDs
Target status LEDs
Figure 2.7 Positions of the system status LEDs and target status LEDs
(1) System status LEDs
Check that the LED1 and LED2 of the system status LEDs are lit immediately after the power is activated. If it is not lit, shut
off the emulator and check the power supply for the emulator is properly connected.
(2) Target status LEDs
Target status LEDs light as shown in Figure 2.8 when the user system is not connected and as shown in Figure 2.9 when a user
system is connected. After turning on the power, only the LED5 (RESET) lights on. Check the target status LEDs
display normally after starting up the emulator debugger.
When the target status LEDs do not display as shown in Figures 2.8 and 2.9, refer to "5. Troubleshooting" (page 95).
Figure 2.8 Target status LEDs display when the emulator starts up normally (when user system not connected)
REJ10J0918-0300 Rev.3.00 February 15, 2007
LED1
POWER
SAFE
LED2
LED3
POWER
CLOCK
RESET
RUN
LED6
COMPACT EMULATOR
When the user system NOT connected:
Setting the JP1 of R0E43664EPBM0
- JP1 is set to INT POWER side:
The power LED does not light when the
user system not connected.
- JP1 is set to EXT POWER side:
The power LED does not light when the
user system connected or not.
: ON
: OFF
SYSTEM
POWER
STATUS
SAFE
COMPACT EMULATOR
R0E436640CPE00
POWER
TARGET
CLOCK
STATUS
RESET
RUN
MADE
MADE IN JAPAN
POWER
CLOCK
RESET
RUN
POWER USB
5.0V
SW
1
J
- +
J
2
1
5.0V
JP2
3.3V
EXT
JP1
INT
LED3
LED4
LED5
LED6
Page 27 of 102
2. Setup