To Do A Check Of The Engine Oil Level - Husqvarna 112C5 Workshop Manual

4. Put the lift lever for the cutting deck in operation
position.
5. Release the clip and remove the drive belt cover.
6. Disengage the spring for the drive belt to loosen the
drive belt tension.
7. Remove the drive belt.
8. For : Hold the cutting deck with 2 hands and pull it
out. Lift the cutting deck and put it against the
product or a wall.
10 - Assembly
9. For : Hold the cutting deck with 2 hands and pull it
out until it stops.
10. Lift the equipment frame lock to vertical position.
WARNING: The lock mechanism can cause
injury to fingers if you do not operate it
carefully. Put the equipment frame lock in
full vertical position.
11. Remove the pin to disconnect the stay from the
cutting deck.
12. Hold the cutting deck with 2 hands and pull it out.
13. Lift the cutting deck and put it against the product or
a wall.

4.8 To do a check of the engine oil level

1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
1342 - 001 - 09.03.2020