Husqvarna 112C5 Workshop Manual page 29

13. Remove the engine.
14. Install in the opposite sequence.
9.2.5 To remove and install the muffler (112C,
112C5)
1. Remove the engine cover. Refer to
engine cover on page 21 .
2. Remove the rear engine cover. Refer to
the rear engine cover on page 22 .
3. Remove the engine side covers. Refer to
the engine side covers 115C on page 21 .
4. Remove the 2 screws (A) and the heat shield (B).
B
1342 - 001 - 09.03.2020
5. Remove the 2 screws (C) and the muffler (D).
6. Replace the gasket between the muffler and the
7. Install in the opposite sequence.
9.2.6 To remove and install the muffler (115C)
To remove the
1. Remove the engine cover. Refer to
To remove
2. Remove the rear engine cover. Refer to
To remove
3. Remove the engine side covers. Refer to
4. Remove the 2 screws (A) on the exhaust pipe.
A
5. Remove the screw (B) on the bracket and remove
6. Replace the gasket between the engine and the
7. Install in the opposite sequence.
9.2.7 To replace the engine oil and oil filter
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
D
exhaust pipe.
engine cover on page 21 .
the rear engine cover on page 22 .
the engine side covers 115C on page 21 .
A
the muffler (C).
exhaust pipe when you install the muffler.
C
To remove the
To remove
To remove
B
C
Repair instructions - 29