Planmeca ProMax 3D s User Manual page 66

11 3D MODEL EXPOSURE
62 Planmeca ProMax 3D s & 3D Classic
Planmeca ProMax 3D Classic
40 mm
Impression
on polystyrene disc
7. Place the model (impression or plaster cast) on the
polystyrene disc so that the model faces the sensor
and proceed as follows:
• Planmeca ProMax 3D s X-ray units:
The volume diameter is 50 mm (2 in.). Use the
positioning joystick to adjust the volume center
lights so that they cross in the middle of your
area of interest. Refer to section 9.8.2 "Moving
image volume horizontally (X and Y lasers)" on
page 44 for details.
• Planmeca ProMax 3D Classic X-ray units:
Position the model so that the distance between
the front edge of the model and the volume
center cross is 40 mm (1.6 in.).
Volume center
lights
8. If not yet done, select the patient in the Planmeca
Romexis program.
User's Manual (3D Imaging)