Planmeca ProMax 3D s User Manual page 30

9 3D PATIENT EXPOSURE
Detaching sensor from C-arm
26 Planmeca ProMax 3D s & 3D Classic
3. Push in the C-arm electrical connector button on the
other side. This will make the electrical connection
between the sensor and C-arm.
NOTE
Do not remove the sensor during imaging process.
1. Push in the C-arm electrical connector. This will
disconnect the electrical connection between the
sensor and C-arm.
2. Turn the locking knob 180 degrees. This will release
the locking mechanism.
3. Carefully pull the sensor out.
NOTE
For safety reasons, wait for at least ten seconds before
you attach a sensor again. The blue indicator light under
the locking knob has to switch off first.
User's Manual (3D Imaging)