User's Manual (3D Imaging)
3.
On the X-ray unit, select the program.
•
For impressions select
3D Models > Impression.
•
For plaster casts select
3D Models > Plaster Cast.
4.
To go to the next screen, select
•
this symbol
OR
•
the forward button.
The positioning lights (volume center lights and volume
bottom light) come on. The volume center lights cross in
the middle of the image volume.
5.
Select the image resolution you wish to use. The
voxel size is shown below the resolution button.
•
Fast: Short exposure time and lower resolution
for archiving purposes
•
High resolution: Long exposure time and higher
resolution for best results
6.
Select the exposure values that you used in the
calibration process for this material. Refer to section
9.5.3 "Adjusting exposure values for current
exposure" on page 39 if you need to adjust the preset
exposure values.
Planmeca ProMax 3D s & 3D Classic
11 3D MODEL EXPOSURE
61